Stove Installation Haxby, York

A black dik geurts Ivar 5 stove instllation

Stove Installation | Hot Box Stoves

A recent install near Haxby York.

Client had a gas fire and marble back and hearth, they wanted it removing and a stove inserted into the recess.

Works to the recess were as follows:

  • Remove the current gas fire and marble inset and hearth.
  • Carefully create a fireplace opening to approximately 950mm x 900mm and install a new reinforced concrete and steel lintel.
  • To the back and sides of the newly formed recess provide a Staggered Back Slate Chamber.
  • Remove the current gas liner (if applicable) and make ready for the flue liner installation.
  • Make good the existing concrete substrate of the constructional hearth as required in preparation for the receipt of the new finish.
  • Supply and adhere to the substrate a sectional slate hearth as discussed.
  • Make good the plaster detail to the recess opening.
  • If necessary, make good the skirting boards up to the edge of the recess so that there are no combustible materials near the appliance.

Stove installation and connection was as follows.

  • Sweep the current flue of debris.
  • Supply and install a 316-grade twin skin flue liner.
  • Supply and sit into position a DG Ivar Wood stove.  
  • Install a 2mm galvanised steel plate fixed to the underside of the concrete lintel and seal between the register plate and chimney with high-temperature sealant.
  • Provide a heat proof matt black stove paint finish to the register plate (prior to fitting).
  • Connect a length of vitreous enamel pipe to the new chimney liner using the appropriate connection component and seal the joint with fire silicone.
  • Make a connection between the stove pipe and the appliance through the hole in the register plate and seal with fire silicone.
  • Back fill and insulate the chimney flue around the base of the flue liner with light weight Vermiculite insulation to help maintain a high flue gas temperature, and because a ‘warm flue is a happy flue’.
  • Complete the chimney flue installation with a Pot Hanging Cowl.
  • Supply and install (position to be agreed) a chimney notice plate outlining details of the installation in accordance with Document J of Building Regulations.
  • Smoke test the appliance by lighting a small fire upon completion to ensure that there is an adequate degree of draw and all connections are sealed.
  • Provide a HETAS certificate of compliance.
  • Dispose of all debris from site as works progress.
  • Provide all relevant plant and equipment for the duration of the works.
  • Provide an Access Platform (Cherry Picker) and all access equipment for the duration of the works to fully comply with The Health and Safety at Works Act.
  • Supply and fit in accordance with building regulations 1 number CO/ Carbon Monoxide Alarm (position to be agreed), mandatory with all stove installations as of 1st October 2010.
A black dik geurts Ivar 5 stove instllation
Haxby Stove Installation
Old Stove Before Fitting
Old Stove Before Fitting

When the works were completed we had another highly satisfied customer.

The stove chosen by the customer was :

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Need some help?
Need some help?
Questions?, We're here to help you!
Connecting...
None of our operators are available at the moment. Please, try again later.
Our operators are busy. Please try again later
:
:
:
Have you got question? Write to us!
:
:
This chat session has ended
Was this conversation useful? Vote this chat session.
Good Bad